Click "BACK" button (above)
to go to previous page.

System 40X
FEATURES
  • Single axis, roll stabilization autopilot
  • 3" ATI programmer/computer
  • System includes seperate programmer/annunciator (shown above), turn coordinator, servo, and pressure transducer
  • Includes heading mode, NAV/APR/REV intercept and tracking, course deviation / NAV flag warnings, roll stabilizer, and control wheel steering (CWS)
  • Stabilizer mode is controlled by roll modifier button mounted on control wheel
  • Capable of turn commands up to 90% of standard rate turn
  • Rate-based system, deriving roll axis control inputs from separate electric turn coordinator
  • Gain enhancement feature for use when tracking GPS & LORAN input signals
  • Includes GPSS steering feature for use with GPS receivers that have roll steering outputs
  • Heading Pre-select is optional* by adding S-Tec course selector Dir. Gyro or HSI with autopilot outputs
  • Building block concept allows upgrading to two-axis System 50 X
  • Manual electric trim option* available
  • Please Note: This system requires a compatiable heading system for heading preselect and NAV intercept capability. If a compatible heading system is not installed, the autopilot reverts to tracker only (no intercept capability) when using any NAV modes


  • NOTE:
    GPSS feature only compatible with GPS receivers that have ARINC 429 outputs and Low Speed Label 121 (bank angle command) and Low Speed Label 312 (ground speed)
    The following is a list of GPS receivers that are compatible with this converter:
    GPS150 and GPS150XL
    GPS155 and GPS155XL
    GPS165
    GNC250 and GNC250XL
    GNC300 and GNC300XL
    GPS400
    GNC420
    GNS430
    GNS530
    KLN-900
    KLN-90B (when used with KA-90 Adapter)

*OPTIONS

SPECIFICATIONS

PROGRAMMER/COMPUTER:
Power Requirements: 14/28 VDC Weight: 2.4 lbs.
Dimensions: 3.3" x 3.3" x 7.5" System Requirements: current= avg. .5 amp; max. 3.0 amp

TURN COORDINATOR:
Power Requirements: 14/28 VDC Flag Voltage Detector: (operating limits) 9.0 VDC approx.
Flag RPM Detector: (operating limits) nominal RPM less 10% Current Requirements: 3 Amp
Weight: 1.8 lbs. Dimensions: 3.275" x 3.275" x 5.62"

ROLL SERVO:
Power Requirements: 14/28 VDC Current Requirements: system value equivalent
Weight: 2.9 lbs. Dimensions: 3.75" x 3.75" x 7.25"